Underfloor heating and your parquet

The trend of underfloor heating requires technically best design floor coverings

More and more underfloor heating systems are installed, as they create a comfortable warmth, atmosphere and thus quality of life. Therefore also the chosen floor covering has to be technically mature and applicable.

Château by adler, the wide and long wooden plank of Adler, has a favorable thermal resitance, even though it is 19 mm thick. Furthermore the Château plank possesses the natural beauty and warmth of the wood – especially with oiled surfaces. These properties and the multi-layered structure render the parquets well suited for installation over underfloor hot water heating systems. You can find the individual thermal resistance of each product either in our technical product data booklet, which you can download or in the description of each product line.

Installation over electric underfloor heating is not recommended in principle. Laying prefabricated parquet flooring on underfloor heating of over 70 W/m2 is also not advisable.

If you use a combines floor heating and cooling system, you have to take care that there will be no condensed water under the parquet flooring.

Preparation of your underfloor for the heating system

Firstly you should read our installing instructions in calm. There you find all important steps for the installation on underfloor heating systems.

Here the most important points, you should be aware of:

Newly applied screeds must dry normally, without heating. The screed must be allowed drying time The waiting period is approx. 28 days. Then your installer of the heating system should start the heating according a specific heating report. Please make sure that your installer fills in and signs this report thoroughly. This report can be found in our infothek for your download.

Other important points after the installation

The surface temperature must not exceed 26°C after laying. The maximum surface temperature for our Deluxe floorboard is 26°C. The ambient temperature and relative humidity of the room should be 19 - 22°C and 50 – 60%.

To prevent heat pockets during the heating period, it is recommended to position furniture with closed bases away from the wall and to provide ventilation holes at the back. Refrain from laying thick, airtight carpets.

Due to the technical and hygroscopic properties of the natural wood product, gaps may appear in the surface of the prefabricated parquet floor, especially with excessive surface temperatures or inadequate atmospheric humidity. Cracks in the grain or drying cracks may already occur should the atmospheric humidity drop below 50% just once. This is not a quality defect. This may be minimised or prevented by maintaining the room ambient temperature and humidity virtually constant at approx. 22°C and 50 - 60%.

Especially beech wood reacts easily in this respect. That is the reason why we do not offer Beech in our parquet programm. The ambient conditions should therefore be closely maintained in the room. Canadian maple, Jatoba and Larch also count among risky timber, especially when ambient humidity is too low.